How To Remove Shingles From A Steep Roof

A complex roof architecture is more time consuming to complete than a simple flat roof due to angles and fitting.

How to remove shingles from a steep roof.

Ways to work on a steeply pitched roof. Step 3 replacing rotten plywood. Chances are the nails that will be securely seated in the wood so a bit of force will be needed with a twisting motion of the roofing shovel or spade. Don t force it shingles rip easily.

Any wood that has become rotten should. Remove the shingles in layers as you work your way up the roof. In some cases you can. Remove all of the shingles on the roof.

Step 2 removing the old shingles. Refrain from pulling out the. Ensure that as you. Check to be sure that the plywood that was under the shingles is still in good condition.

Use the claw of a hammer to loosen the adhesive under the tabs 2 rows above the damaged shingles and then loosen any exposed nails with the claw. Removing asphalt shingles is a big job and you might be temped simply to lay the new roof over the old one. The possibility of slipping and falling makes working on any roof dangerous but it s especially so if the roof rises more than 4 feet for every 12 feet of. If any nails will not come free drive them into the decking with your hammer.

Wedge the notch of the pry bar under the shingle at the nail head then pry up both shingle and nail. Remove leftover debris from the roof. The shingles will roll up like a ball in front of the fork. Remove shingles in a 2 to 3 ft wide section as you work down the roof.

Slide the split ends of the hammer under and around the nail. You will want to start from one side of your roof and work your way to the other side. In order to replace damaged roof shingles you need to remove the damaged shingle install the new one and seal the edges. Depending on the pitch additional equipment may also be necessary.

Nail on the new shingle nail down the new shingle propping the tabs. Continue tearing off the shingles and underlayment until you reach the roof jacks then start over at the top of the roof. Gently tap a flat bar under the shingles to break the seal down strips free. Use the split end of a claw hammer to pry out nails still holding bits of shingles onto the roof.

Push the shingles down to the roof jacks. Use the shovel to pry the old shingles from the roof decking. A steep roof pitch can add to the cost of installation as it will be more time consuming to work on a steeper pitch.