How To Remove Sliding Wardrobe Doors From Track

The floor guide keeps the doors level across the door opening.

How to remove sliding wardrobe doors from track.

Be careful when pulling a door out of the track as many of the sliding doors can be quite heavy. Because sliding doors don t fold out the way bifold doors do they allow access to only half the width of the opening at a time. Then try lifting it up a little and pulling it towards you. Most of the time the door will pop right off.

At the bottom of the opening is a floor guide with two channels. Once this is complete repeat the process with the inside closet door. Sliding closet doors operate on rollers that are positioned in tracks at the top jamb and floor allowing the doors to bypass each other in the tracks. To do this lower the top rollers on the bypass door.

Next carefully lift the door up at a slight angle to remove the bottom rollers from the track. Adjusting the sliding doors for vertical adjustment of the shaker linear minimalist eclipse metro and icon doors. Pull the door toward the room to angle the door. Both panels disconnect in the same manner.

The slider rails are tracks that hold the upper rollers of each sliding panel. Lift the door when the door is tilted between 10 and 20 degrees. If there are brackets at the bottom remove the screws that secure the door to the brackets before lifting the door out. Then angle the door towards you and pull gently detaching the door from its top track.

Slide the front sliding door to the middle of the door opening. How to remove sliding bypass closet doors from their track. For wardrobes with 4 doors the outer doors will go on the back track and the 2 middle doors will meet in the middle on the front track. Remove the door from a solid track if this is the kind you have.

Use a philips screwdriver on the bottom wheel to raise or lower the door. Remove the outside closet door by first sliding the door to the center of the track. Maintaining sliding closet doors. Getting the closet doors off the slider rails requires removing the floor guide at the bottom.